ELF4/4 (44d d d d0O /usr/lib/ld.so.15B;')/?0.>8$*A9=143<:2%!7(,-#@ "5+&6Ԁ̂@PX  @ l d 04T X  !*/ <Id _Ȉfk` s' y N@(Hx ؈T8 #d *\74  <hB@* _startread_mcountdevnamefi_environ_end_ex_registercount_by_100_GLOBAL_OFFSET_TABLE_atexitexitdevpath_init_DYNAMICdatarrayargprintfstrcatioctlwrite_ex_deregisterenvironerrno__fpstart__longdouble_usedopenstrcmppass_countscanfii_edata_PROCEDURE_LINKAGE_TABLE__etext_lib_versionmainlseek_finilibc.so.14#812p&t4x'|-97.6/@05h%l%ph%th%xh%|h%h %h(%h0%h8p%h@`%hHP%hP@%hX0jjRt+h@!ETRU RPT  PjUVhlhhhdhhh<hhĖh5Vh<hV#u jQh5`V}VhD?jVt=u5h\j hh D59 =u5hjhh D 5 =thėjh hh D5 =u5h(Fj,hhD5j =u5hdjhh D 5. =thjhؘ hhD5 =u5hwj] hhD5 =u5h81jhhD5U =u5htjj h5, =thjhhjj5 =u5h$^jDhhD5 =u5hPjhhD5< =u5hjhh D@5 =u5h̚j|=otPhrjXhhD5 =u5h8,jhh D@5Z =u5htj=AtPhjhh D 5 =u5hjvhh D@5 =u5hTj:=tPhP0jhhD5T =u5hjhh D@5 =u5hj=AtPhjpUUhhD5 =u5h(Dj*hhD@5r =u5h`j=UUtPhjhhD5 =u5hȝjhhD@5 =u5hbjH=tPh8>j$fE@=|hhD5> =u5hhjh h52 =u5hj~hhD@5 =u5hܞ\jB=tPh8j4hhD5\ =u5hXjhhD5 =u5hjh h5 =u5hȟpjVf Ef4tQPh6 j@=| A @doPhPRS[F<у:tQ[S[@у:tQ[ IKON 10116/10118 PCI bus DR11-W emulator loop-back test THIS VERSION FOR LATER 10116 AND ALL 10118 BOARDS THAT CAN UN-SWAP DMA BYTES IN SPARC INSTALLATIONS A suitable loop-back cable must be installed before this test is run. Three timeout test will be done first - each takes 10 seconds. The timeout tests will cause a DMA timeout message on the console. Following that an endless loop of loop-back tests will be performed. At the end of every 100 successfull passes, the pass count will be output. An error will print a message and halt the tests. Use control-C to terminate the tests. Please enter the name of the device to be tested: (idr0...idr9, quit) %15s testing device %s could not open device, errno = 0x%x test# 00.10: error setting attention timeout, errno = 0x%x test#00.20: attention wait timeout test did not time out attention wait timeout test OK test# 00.30: error setting ready timeout, errno = 0x%x test# 00.40: error sending go pulse, errno = 0x%x test# 00.50: ready wait timeout test did not time out ready wait timeout test OK test# 00.60: error issuing aclo-fnct2 pulse, errno = 0x%x test# 00.70: error setting dma timeout, errno = 0x%x test# 00.80: error setting read pulses, errno = 0x%x test# 00.90: dma timeout test did not time out dma timeout test OK starting endless loop-back tests test# 10.00: lseek error, errno = 0x%x test# 10.01: error issuing master clear pulse, errno = 0x%x test# 10.10: error setting function bits, errno = 0x%x test# 10.20: error reading status, errno = 0x%x test# 10.30: incorrect status bits: status = 0x%x test# 10.40: error setting function bits, errno = 0x%x test# 10.50: error reading status, errno = 0x%x test# 10.60: incorrect status bits: status = 0x%x test# 10.70: error waiting for attention, errno = 0x%x test# 10.80: error reading status, errno = 0x%x test# 10.90: incorrect status bits: status = 0x%x test# 20.10: error pulsing acf2, errno = 0x%x test# 20.20: error reading status, errno = 0x%x test# 20.30: incorrect status bits: status = 0x%x test# 30.10: error writing data out, errno = 0x%x test# 30.20: error reading data in, errno = 0x%x test# 30.30: incorrect data in: data = 0x%x test# 30.40: error writing data out, errno = 0x%x test# 30.50: error reading data in, errno = 0x%x test# 30.60: incorrect data in: data = 0x%x test# 40.01: error setting write pulse, errno = 0x%x test# 40.10: error doing dma write, errno = 0x%x test# 40.20: error reading data in, errno = 0x%x test# 40.30: incorrect data in: data = 0x%x, should be 0xfff test# 50.10: error writing data out, errno = 0x%x test# 50.11: error setting read pulse, errno = 0x%x test# 50.10: error doing dma read, errno = 0x%x test# 50.20: incorrect read buffer data: datarray[0x%x]=0x%x, should be 0x1234 pass count = %d Έވ.>N^n~<LH  @ R̂ d`X@x00/dev/quitԀ̂@PX  @ l d 04T<" ,07>GXVbryL 0 X  d Ȉ`  '  N$@(/(6H<xB QY_؈iT{8d \4  h@* idr.loop.testcrti.s_ex_shared0_ex_text0_ex_range0crt1.s__fstd.s__fnonstd_usedvalues-Xt.cidr.loop.test.ccrtn.s_ex_shared1_ex_text1_ex_range1_startread_mcountdevnamefi_environ_end_ex_registercount_by_100_GLOBAL_OFFSET_TABLE_atexitexitdevpath_init_DYNAMICdatarrayargprintfstrcatioctlwrite_ex_deregisterenvironerrno__fpstart__longdouble_usedopenstrcmppass_countscanfii_edata_PROCEDURE_LINKAGE_TABLE__etext_lib_versionmainlseek_fini@(#)crti.s 1.4 94/08/22 SMI@(#)libc-i386:libc-i386/csu/crt1.s 1.18@(#)crt1.s 1.3 93/12/01 SMIas: 3.0.1-alpha 03 Oct 1994@(#)values-Xt.c 1.6 89/10/24 SMI@(#)synonyms.h 1.1@(#)math.h 2.3 93/09/07@(#)floatingpoint.h 2.3 93/09/07 SunPro@(#)stdio.h 1.34 94/06/07 SMI@(#)feature_tests.h 1.6 93/07/09 SMI@(#)ieeefp.h 2.3 93/09/07 SunProacomp: PC3.0.1 21 Jan 1995 Sun C 3.0.1hc2.6c -O0 -386 -fstrict -on SHAREABLE ../src/values-Xt.c as: PC3.0.1 21 Jan 1995@(#)fcntl.h 1.9 93/10/12 SMI@(#)types.h 1.38 95/11/14 SMI@(#)feature_tests.h 1.7 94/12/06 SMI@(#)isa_defs.h 1.7 94/10/26 SMI@(#)machtypes.h 1.5 94/11/05 SMI@(#)select.h 1.10 92/07/14 SMI@(#)time.h 2.47 95/08/24 SMI@(#)time.h 1.23 95/08/28 SMI@(#)siginfo.h 1.36 95/08/24 SMI@(#)machsig.h 1.4 94/11/05 SMI@(#)faultcode.h 1.15 92/07/14 SMI@(#)fcntl.h 1.31 95/01/19 SMI@(#)stdio.h 1.39 95/12/04 SMI@(#)va_list.h 1.6 96/01/26 SMI@(#)errno.h 1.13 95/09/10 SMI@(#)errno.h 1.15 95/01/22 SMI@(#)ioccom.h 1.10 92/07/14 SMIacomp: PC3.0.1 21 Jan 1995 Sun C 3.0.1hc2.6c -O0 -386 -fstrict -on SHAREABLE idr.loop.test.c as: PC3.0.1 21 Jan 1995@(#)crtn.s 1.4 94/08/22 SMIld: (SGU) SunOS/ELF (LK-2.0 (S/I) - versioning) < 4<$4z*b.interp.hash.dynsym.dynstr.rel.ex_shared.rel.bss.rel.plt.plt.text.init.fini.rodata.got.dynamic.exception_ranges.ex_shared.data.bss.symtab.strtab.comment.stab.index.stab.shstrtab.stab.indexstr.stabstrvalues-Xt.cXt ; V=3.0 ; R=3.0/net/cicogna/export/cicogna1/atlas/lang/SCCS_DIRECTORIES/lang/csu/i386; /net/cicogna/export/cicogna/atlas/build-dir//cbld-Jan21-3/bin/cc -c -O ../../inc -I. -o values-xt.o ../src/values-Xt.c -W0,-xpidr.loop.test.cXt ; V=3.0 ; R=3.0/usr/wdw/pci.idr.x86; /opt/SUNWspro/bin/../SC3.0.1/bin/cc -c idr.loop.test.c -W0,-xpmainidr.loop.test.cԀ  ̂ R @@. PP7 XX`@E K'Q@@*Wll _dd Dd m00!44! TT!@!N!)&u(-T l- -f.g /